Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I N S TA L L AT I O N :
The fi xing bracket (No.7) with the fi xing piece (No.8) and the adjusting bracket (No.9) remain assembled
on the engine support as in case of removal. The installation hole should be processed lightly with
emery paper and grease before the installation, so that the bearing does not tilt.
•
Step 1: Place the pressure pad (No.6) onto the installation hole above the
engine support and mount the nut (No.12) with the installation spindle (No.1).
•
Step 2: Place the fi xing block (No.10) between the two bearings and press the bearing lightly into
the installation cone ring (No.5).
Note, that the lines on the installation cone
ring (No.5) are approximately aligned with the
recess of the two bearings
•
Step 3: Insert the thus pre-assembled bearing with the cone ring (No.5) over the installation
spindle (No.1). Then mount the pressure pad removal / installation (No.2) and the nut with thrust
bearing (No.14) from below onto the spindle.
•
Step 4: Align the pre-assembled bearing with the cone ring (No.5) with the lines with respect
to the recess in the engine support and apply pre-stressing. Now the double bearing can be
installed.
10
Werbung
