Installation; Preparing For Installation; Finishing Installation Of The Appliance - Blaupunkt 5DW69250 Gebrauchs- Und Montageanleitung

Installation

Preparing for installation

Caution!
Ensure that there are no electric wires, gas or water pipes in the
area where holes are to be made.
Mark a vertical centre line on the wall from the ceiling to the
1.
lower edge of the extractor hood.
Mark the positions for the screws and the contour of the
2.
attachment area.
Drill 8 mm Ø holes to a depth of 80 mm and press the wall
3.
plugs flush with the wall.
Screw on the fixing bracket for the flue duct.
4.
Screw in 2 securing screws with washers to approx. 5 mm.
5.
22
¨
©
Installation
Attaching and aligning the appliance.
1.
Mark the hole for the safety screw.
2.
Remove the appliance once more.
3.
ª

Finishing installation of the appliance

Drill an 8 mm Ø hole to a depth of 80 mm for the safety
1.
screw and press the wall plug flush into the wall.
Initially remove the protective foil from the back of the
2.
appliance and, following installation, remove the foil
completely.
Attach the appliance.
3.
Screw in the safety screw - and washer - and tighten all the
4.
screws. ª
¨
©
ª
©
¨