Automatic Safety Cut-Out; Setting The Correct Time; Wipe Protection; Energy Consumption Indicator - Blaupunkt 5RH84351 Gebrauchsanleitung

Automatic safety cut-out

en

Setting the correct time

Use the symbol to select the kitchen timer and reset
0
the time.
bAutomatic safety cut-out
If a hotplate has been switched on for a long time
c u t - o u t A u t o m a t i c s a f e t y
without the setting being changed, the automatic time
limit is activated.
The hotplate stops heating.
heat indicator flash alternately on the hotplate display.
The display goes out when you touch any control. You
can make new settings.
When the time limit is activated depends on the heat
setting selected (1 to 10 hours).
kWipe protection
If you wipe over the control panel while the hob is
W i p e p r o t e c t i o n
switched on, settings may be changed.
To prevent this from happening, your hob has a wipe
protection function. Touch the
off. The display light above the
control panel is locked for 30 seconds. You can now
wipe over the control panel without changing any
settings.
The primary switch is not affected by the wipe
Note:
protection function. You can switch off the hob at any
time.
[Energy consumption
indicator
You can use this function to display the total energy
n i n d i c a t o r E n e r g y c o n s u m p t i o
consumption between switching the hob on and off.
Once switched off, the energy consumption is displayed
in kilowatt hours (e.g. 1.08 kWh) for 10 seconds
The accuracy on the display depends on the voltage
quality of the power supply, among other factors.
30
and the / residual
"‰ • œ
symbol. A beep goes
Ö
symbol lights up. The
Ö
The display has not been activated. You can find out
how to activate the display in the Basic settings
section.~ Page 30
QBasic settings
Your appliance has various basic settings. You can
B a s i c s e t t i n g s
adjust these settings to meet your own needs.
Display Function
Automatic child safety lock
™‚
Switched off.*
‹
Switched on.
‚
Manual and automatic child safety lock switched off.
ƒ
Beep
™ƒ
Confirmation signal and operation error signal are
‹
switched off (primary switch signal always remains).
Only the operation error signal is switched on.
‚
Only the confirmation signal is switched on.
ƒ
Confirmation signal and operation error signal switched
„
on.*
Energy consumption display (Ask your electric com-
™„
pany what the mains voltage is)
Consumption display switched off.*
‹
Consumption display with mains voltage at 230 V.
‚
Consumption display with mains voltage at 400 V.
ƒ
Consumption display with mains voltage at 220 V.
„
Consumption display with mains voltage at 240 V.
...
™† Automatic timer
Switched off.*
‹‹
Cooking time after which the hotplates switch off.
‹‚ - ŠŠ
Duration of the timer end signal
™‡
10 seconds.*
‚
30 seconds
ƒ
1 minute.
„
Activation of the heating elements
™ˆ
Switched off.
‹
Switched on.
‚
Last setting before the hotplate was switched off.*
ƒ
Selected time for the hotplate
™Š
Unlimited: the most recently selected hotplate can always
‹
be adjusted without having to select it again.*
Once you select a hotplate, you have 10 seconds to adjust
‚
it, after which you will have to select it again in order to be
able to adjust it.
*Basic setting