Battery Charge Indicator - Bosch Purion BUI215 Originalbetriebsanleitung

English – 4
Displays and configurations of the
on-board computer

Battery charge indicator

The battery charge indicator (g) displays the eBike battery's
state of charge. The state of charge of the eBike battery can
also be checked on the LEDs of the battery itself.
In the indicator (g), each bar in the battery symbol repres-
ents approximately 20 % capacity:
The eBike battery is fully charged.
The eBike battery should be recharged.
The LEDs of the battery charge indicator on the
battery go out. The capacity for assisting the drive
has been used up, and assistance is gently
switched off. The remaining capacity is made
available for the lighting. The indicator flashes.
The capacity of the eBike battery is enough for
about two hours of lighting.
Speed and distance indicators
The speedometer (a) always displays the current speed.
Indicator (i) always displays the last setting as standard. Re-
peated medium-length presses
the trip distance TRIP, the total distance TOTAL and the
range of the battery RANGE one after the other. (Briefly
pressing the button – will decrease the assistance level.)
To reset the trip distance TRIP, select the trip distance TRIP
and simultaneously press and hold
The display will initially show RESET. If you continue to press
both buttons, the trip distance TRIP will be set to 0.
To reset the range of the battery RANGE, select the battery
range RANGE and simultaneously press and hold
tons + and –. The display will initially show RESET. If you
continue to press both buttons, the trip distance TRIP will be
set to 0.
You can switch the displayed values from kilometres to miles
by holding down the button – and briefly pressing
on/off button (1).
The versions of the subsystems and their model part num-
bers can be displayed for the purposes of servicing,
provided the subsystems divulge this information (depend-
ent on the subsystem). With the system switched off, simul-
taneously press the buttons – and + and then press the on/
off button (1).
The USB port is reserved for connecting diagnostic systems.
The USB port does not have any other function.
The USB connection must always be completely
u
sealed with the protective cap (8).
Action
Switch on on-board computer
Switch off on-board computer
Increase assistance
1 207 020 XBP | (11.03.2020)
of the button – will display
the buttons + and –.
the but-
the
Buttons Duration
+
Action
Decrease assistance
Display TRIP, TOTAL, RANGE,
assistance modes
Switch on bike lights
Switch off bike lights
Reset trip distance
Activate push assistance
Implement push assistance
Switch from kilometres to miles
A)B)
Display the versions
C)
Adjust display brightness
A) The eBike system must be switched off.
B) The information is shown as scrolling text.
C) The display must be switched off.
Buttons Duration
–
–
+
+
– +
1.
WALK
2. Any
+
– 1. Keep
pressed
2.
– + 1. Keep
pressed
2.
– + 1. Keep
pressed
2.
– or +
Bosch eBike Systems