Kenwood KMM-BT34 Bedienungsanleitung Seite 12

BLUETOOTH®
Text message notification
When the phone receives a text message, the unit rings and "SMS
RECEIVED" appears.
• You cannot read, edit, or send a message through the unit.
• To clear the message, press any button.
Use Voice Recognition
1
Press and hold to activate Voice Recognition.
The connected phone (which has been paired the earliest) is
activated. However, if priority device is connected, pressing and
holding activate the priority device. ( 12, DVC PRIORITY)
2 Speak the name of the contact you want to call or the voice
command to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to
the instruction manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of
iPhone.
Bluetooth mode operations
1
Press to enter Bluetooth mode.
2 Turn the volume knob to make a selection (see the following
table), then press the knob.
3
Press and hold to exit.
To return to the previous setting item or hierarchy, press
To enter [PHONE BOOK] directly, press
Press again to switch between the phonebooks of the connected
phones.
1 Press the volume knob to select a name or a phone number.
CALL
• "I" indicates call received, "O" indicates call made, "M" indicates call
HISTORY
missed.
• Press DISP SCRL to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
10
.
. ( PHONE BOOK)
PHONE BOOK 1 Turn the volume knob to select a name, then press the knob.
2 Turn the volume knob to select a phone number, then press the knob to call.
• If the phone supports PBAP, the phonebook of the connected phone is
automatically transferred to the unit when pairing. If the phone does not
support PBAP, "TRANSFER PB" appears. Transfer the phonebook manually.
( 12, TRANSFER PB)
• Contacts are categorized as: MO (mobile), HM (home), OF (office), OT (others),
GE (general)
• This unit can display only non-accent letters. (Accent letters such as "Ú" is
showns as "U".)
• If the phonebook contains many contacts, ( 11, Select a contact by name).
1 Turn the volume knob to select a number (0 to 9) or character ( , #, +).
NUMBER
2 Press S / T to move the entry position.
DIAL
1
Repeat steps and
3 Press the volume knob to call.
VOICE Speak the name of the contact you want to call or the voice command to control
the phone functions.
BATT* LOW/ MID/ FULL: Shows the strength of the battery.
SIGNAL* NO SIGNAL/ LOW/ MID/ MAX: Shows the strength of the current received signal.
SETTINGS
AUTO 1 — 30: The unit answer incoming call automatically in the selected time. ;
ANSWER OFF: Cancels.
RING MODE SYSTEM: The unit rings to notify you when a call/text message comes in.
(Default ring tone is different according to the paired device.)
• CALL: Selects your preferred ring tone (TONE 1 — 5) for incoming calls.
• MESSAGE: Selects your preferred ring tone (TONE 1 — 5) for incoming text
messages.
PHONE: The unit uses the connected phones' ring tone to notify you when a
call/text message comes in. (The connected phone will ring if it does not support
this feature.)
SMS ON: The unit rings and "SMS RECEIVED" appears to notify you of an incoming
NOTIFY* text message. ; OFF: Cancels.
* Functionality depends on the type of the phone used.
2
until you finish entering the phone number.
Default: XX