Noise/Vibration Information - Bosch GSR Mx2Drive Professional Originalbetriebsanleitung

OBJ_BUCH-1208-001.book Page 22 Tuesday, June 1, 2010 2:23 PM
22 | English
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
21.04.2010

Noise/Vibration Information

The measured values of the machine are listed in the table on page 316.
Noise and vibrational values (vector sum of three directions) determined
according to EN 60745.
The vibration emission level given in this information sheet has been
measured in accordance with a standardised test given in EN 60745 and
may be used to compare one tool with another. It may be used for a pre-
liminary assessment of exposure.
The declared vibration emission level represents the main applications
of the tool. However if the tool is used for different applications, with
different accessories or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also take into
account the times when the tool is switched off or when it is running but
not actually doing the job. This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to protect the operator from the ef-
fects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
2 609 140 750 | (1.6.10) Bosch Power Tools