General Description; Preparation For Use; Temperature Setting - Cole Parmer Stuart SI19 Bedienungsanleitung

Thank you for purchasing this piece of Stuart
equipment. To get the best performance from the
equipment please read these instructions carefully
before use.
For your own safety and that of others
please read and understand the safety
advice given in section 9.0 of this
manual before using the equipment.
If the equipment is not used in the manner
described in this manual the protection provided
might be impaired.

1 General description

CAUTION: Keep fingers clear when
operating door.
CAUTION: Use care when removing
vessels from the incubator as parts may
be hot.
The SI19 mini incubator has been specially
designed for accurate temperature controlled life
science applications. The stainless steel chamber
features 4 shelves which are easy to slide in and
out or quick loading and unloading.
The SI30H Hybridisation incubator /shaker features
advanced temperature controlled forced air
circulation with clear bright LED digital
temperature display. The unit comes complete
with a seven bottle rotisserie which rotates on
guided rollers. Rotation speed is variable between
2 and 10 rpm. A platform is fitted to the back of
the incubator which drops forward to form a
1 2
Figure 3: Front panel controls
Rotisserie / shaker controls (SI30H only)
1. Rotisserie/shaker ON/OFF button
2. Rotisserie/shaker speed selector dial
3. Motor on indicator
3 4
rocking shaker with variable speed of 10 to 50
oscillations per minute. A rotisserie for two 70mm
diameter bottles is available as well as a range of
specially designed hybridisation bottles.

2 Preparation for use

2.1 Remove all packaging and place the incubator
on a level working surface, ensuring that there
is sufficient room above the instrument to
allow the door to be opened fully.
2.2 Leave the unit to stand for a minimum of 3
hours. This will allow acclimation to the new
ambient temperature.
2.3 Follow the instructions for Electrical Installation
given in section 8 of this manual and connect
the instrument to the electricity supply.
2.4 Connect the power cable to a suitably
grounded electrical outlet. The correct
operating voltage of the incubator is found on
the product information label on the rear of
the instrument.
2.5 Turn the Mains ON/OFF switch located at the
back of the unit ON.
2.6 The incubator is now ready for use.

3 Temperature setting

(model SI19 & SI30H)
3.1 The incubator temperature controls are
located on the right hand side of the control
panel (number 4 to 7 in figure 3).
5
Temperature controls (SI19 & SI30H)
4. Temperature on / off button
5. Press to set button
6. LED temperature display
7. Temperature selector dial
6 7
1