Mounting, Connection - ZAMEL RNP-01 Bedienungsanleitung

CONNECTION
DESCRIPTION
Radio transmitter RNP-01 realises remote control function of devices. It is mounted
in a junction box and under the existing switch (monostable pushbuttons). This so-
lution is very useful and results in easy installation of EXTA FREE system without
interference in existing wiring system. There is a possibility of using electroinstalla-
tion equipment of any manufacturer (no design limit).
FEATURES
● radio transmitter mounted in Ø 60 mm junction box,
● remote control of EXTA FREE system receivers,
● possibility of connection to a traditional household switch,
● low power consumption, adapted to constant operation,
● possibility of independent control of four receivers,
● wide range of operation (up to 200 m),
● possibility of simultaneous switching on/switching off any number of EXTA FREE
system receivers,
● possibility of increasing operation range by means of RTN-01 retransmitter.

MOUNTING, CONNECTION

1. Disconnect power supply by the phase fuse, the circuitbreaker or the switch-
disconnector combined to the proper circuit.
2. Check if there is no voltage on connection cables by means of a special
measure equipment.
3. Connect the cables with terminals in accordance with the installing diagram.
4. Install RNP-01 device in installation cable box.
5. Switch on the power supply from the mains.
The device is ready to operate after correct mounting and connection. Releasing
the system by a monostable push-button connected to one of four release termi-
nals (IN1-IN4) causes the RNP-01 device to send a radio control signal added
to this input (channel). LED red diode signals the transmission is on. Device
programming procedure (adding a transmitter to receiver's memory) is de-
scribed in manual instructions of particular EXTA FREE receivers.