Troubleshooting - Polar GL001 Bedienungsanleitung

Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
back of the appliance.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser,
taking care not to damage the fins.
Removing the Doors (Sliding Doors only)
When cleaning the appliance or replacing the lamp it may be necessary to remove the doors to improve
access.
To remove the doors:
1. Holding the sides of the first door, lift the door into the upper runner.
2. Pull the bottom of the door out and down simultaneously so the door clears the bottom runner.
Note: The automatic door-closing system means that the doors are attached to
the appliance by a cord. Do not break or remove this cord.
3. Place the door to the side of the appliance.
4. Repeat for the remaining doors.
5. To replace the doors, slot them into the upper runner and then push the bottom of the door in and
down to slot it in to the bottom runner.

Troubleshooting

If your appliance develops a fault, please check the following table before making a call to the Helpline.
Fault
The appliance is not
working
GL001-GL017_GE997-GE999_ML_A5_v7_20210301.indb 5 GL001-GL017_GE997-GE999_ML_A5_v7_20210301.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
UK
5
2021/3/1 15:03 2021/3/1 15:03