Selection Of Installation Equipment - Hoover HIE844SB1 Bedienungsanleitung

Installation

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by the
heat radiation from the hotplate. As shown below:
H
D
X
B
L(mm) W(mm)
770 520
Under any circumstances, make sure the Induction cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the Induction cooker hob is
in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760mm.
A(mm) B(mm)
760 50 mini
L
W
X
X
H(mm)
60
C(mm)
20 mini Air intake
X
A
D(mm) A(mm)
+4
56 750
+1
D E
Air exit min.5mm
EN-28
F
Min.3mm
B(mm) X(mm)
+4
495 50 mini
+1