Listening To The Radio - New One AR390DAB Benutzerhandbuch

Switching Loudness on /off
By this function, you can increase the low frequency, which can improve sound sensitivity.
Noted: Please refer to "LISTENING TO THE RADIO" for others items operation.

LISTENING TO THE RADIO

Selecting band
In DAB or FM radio mode, repeatedly press BND/ AMS/ TRANS button to select bands in following
order: DAB1 DAB2 DAB3 or FM1
LISTENING TO DAB/DAB+ RADIO
1. When the unit is ON, press MOD button repeatedly to select DAB mode. The unit will start
automatic scan for DAB/DAB+ stations if it's the first time to use. The display will change to "SCAN".
A progress bar will show the progress of the scan and the number of stations found during the scan
will also be displayed.
2. When the scan is complete, the unit will select the first available station and start to play automatically.
Stations will be listed in numerical and then alphabetical order by default.
Note: When the DAB/DAB+ radio station list is stored, it will not search automatically again. Press and
hold BND/ AMS/ TRANS button to search and list station.
3. Use or to select through the list of stations.
Note:
- If no broadcasts are found by DAB/DAB+ scan, "NO SERVICE" appears in the display.
- For a better reception, extend the antenna or do the full scan again in another place.
- During the search operation, the sound level is automatically muted.
FM2 FM3.
GB - 5
LISTENING TO FM RADIO
Manual/ automatic tuning
- Manual Tuning
Press and hold or button until "MANUAL" shows on display, then press
to select a station downward or upward. Press and hold
faster speed.
Note: it will return to automatic tuning mode if no key is pressed within 5 seconds. "AUTO" will show
on display 2 seconds.
- Automatic Tuning
Press or button once, the radio automatically searches a station upward or downward
respectively and plays when it finds a station. Press
Scanning and memorizing stations
This unit can store 18 FM and 18 DAB/DAB+ stations.
- By BND/ AMS/ TRANS button
In DAB or FM radio mode, press and hold BND/ AMS/ TRANS button for 3 seconds to start scanning
for stations and store them automatically in memory. All preset stations are scrolled during few seconds
under your selected band. To remain on a station, press again the BND/ AMS/ TRANS button.
- By number button 1- 6
1. In DAB or FM radio mode, tune to a station by
2. Press and hold one of the 1- 6 number buttons for 2 seconds until LCD shows the corresponding
number, which indicates that station is stored in the corresponding number button.
3. Press 1- 6 number buttons to listen to stored stations.
4. When you are listening to a station stored on a number button, press and hold another number
button for more than 2 seconds to store the station on this number button.
Note: The unit can be stored up to 6 stations for each band.
- STEREO/MONO
Repeatedly press SEL/VOL knob to select "STEREO/ MONO" mode. FM listening is generally done in
Stereo mode. However, if the signal is weak or reception is not as good as you would like, switching to
Mono mode usually improves the overall sound quality.
- DX / LOCAL (DISTANCE/ LOCAL)
Repeatedly press SEL/VOL knob to select "DX/LOCAL" mode.
DX: The weak signal out-of-town stations may be received.
LOCAL: The strong signal local stations can be received.
- AREA (EUROPE/AMERICA)
To select different area.
or
or button to tune the station with a
or buttons again to stop scanning.
or button.
GB - 6
continuously