Troubleshooting Guide - Metabo TP 6600 Originalbetriebsanleitung

Cleaning the impeller
1. Undo Phillips screws on pump base plate.
If necessary push back the two clips on
pump base plate using a screwdriver.
2. Remove base plate.
3. Clean impeller.
4. Mount base plate, fasten screws and if
necessary secure with the clips.
6.2 Pump storage
A
Caution!
Frost damages the pump and accesso-
ries as both always contain water!
If there is a danger of frost disassemble

pump and accessories and store in frost-
free conditions.
7. Troubleshooting
A
Danger!
Prior to all servicing:
Unplug.
7.1

Troubleshooting guide

Pump does not run:
No mains voltage.

– Check cables, plug, outlet and mains
fuse.
Mains voltage too low.

– Use an extension cable with sufficient
conductor diameter.
Motor overheated; motor protection relay

tripped.
– Eliminate the cause of overheating
(pump blocked by foreign objects?).
– After cooling the pump will switch ON
again.
Float switch does not switch pump ON

when water level rises.
– Make sure the float switch can move
unrestrictedly.
If, despite sufficient mobility of the float
switch, the pump does not switch ON:
send the pump to the service centre in
your country.
Motor hums, but does not start:
Pump blocked by foreign objects.

– Clean impeller.
Pump runs, but does not pump properly:
Delivery head too high.

– Observe max delivery head (see 'Tech-
nical Specifications').
Discharge hose kinked.

– Straighten discharge hose.
Discharge hose leaky.

– Seal discharge hose; tighten screw fit-
tings.
Pump runs very noisily:
Pump is sucking air.

– Ensure there is a sufficient water sup-
ply.
– Foreign objects are present (clean
pump).
– Manual mode has been set (shallow
water suctioning).
– Hold pump at an angle when submerg-
ing.
Pump runs continuously:
Float switch does not reach cut-out posi-

tion.
– Make sure the float switch can move
unrestrictedly.
8. Repairs
A
Danger!
Repair of power tools must be carried out by
qualified electricians only!
Power tools in need of repair can be sent to
the service centre in your country. Refer to
spare parts list for address.
Please attach a description of the fault to the
power tool.
9. Disposal
Power tools do not belong in the
household rubbish. According to
European
Directive 2002/96/EC on waste
electrical and electronic
equipment, electrical waste must
be collected separately and taken
to an environmentally friendly recycling
facility.
Contact your local council for information on
disposal of the used tool.
All packaging materials are recyclable.
ENGLISH
15