Engine Oil Change; Air Cleaner Maintenance - Honda Power Equipment UMK435E Betriebsanleitung

ENGINE OIL CHANGE

NOTE : Drain the oil while the engine is still
warm to assure rapid and complete draining.
1. Check the fuel tank cap [2] is tightened.
2. Remove the oil filler cap [1] and drain the oil into the oil container
by tipping the engine toward the oil [3] filler neck.
3. Refill with the recommended and check the oil level [4] (see
page 6).
[4]
Engine oil
Oil tank capacity
4. Install the oil filler cap [1].
CAUTION:
• Wash your hands with soap and water after handling used oil.
NOTE : Please dispose of used motor oil in a manner that is
compatible with the environnement. We suggest you take it in a
sealed container to your local service station for reclamation. Do not
throw it in the trash or pour it on the ground.
10 EN
908697Z_HONDA_GB.indd 10
C11 C10
SAFETY
[2]
[1]
[3]
[1]
[4]
[4]
UMK425E UMK435E
SAE 10W30
0,08 l (80 cc) 0,10 l (100 cc)

AIR CLEANER MAINTENANCE

The foam air filter element must be cleaned regularly to prevent
impurities from entering the engine and causing premature wear. A
dirty air filter will reduce engine power and increase fuel
consumption.
CAUTION:
• Never run the engine without the air filter, as this could cause
premature wear of the engine.
1. Open the air filter cover [5] and remove the filter [6] from the filter
housing [7].
[5] [6]
2. Clean the filter with warm soapy water or in a nonflammable
solvent and then leave to dry.
3. Dip the element in clean engine oil and squeeze out the excess
oil.
4. Reinstall the foam filter element and the filter cover.
LUBRICATING THE TRANSMISSION HEAD
1. Remove the bolt [9] from the transmission head.
2. Insert the nozzle of the tube of special lithium grease (available
from your Honda dealer) and fill with grease while turning the
cutting attachment so that the grease is properly distributed.
Continue until grease comes out of the bolt hole [8].
3. Reinstall the bolt and tighten moderately.
[7]
[9]
18/07/12 15:30