Landxcape LX795 Installationsanleitung Seite 12

Only for reference
LED light indicator on
the charging base
Light does not turn on There is no power.
Boundary wire is connected successfully;
Green light on
Landxcape
The boundary wire isn't connected.
Red light on
Power supply is connected successfully, while
the wire is connected unsuccessfully.
Green light flashing Landxcape
WARNING
• If your Landxcape TM is outside its territory, it will not move and "
Move it inside its territory and repeat Verification.
• If your Landxcape is inside its territory but "
TM
• Your Landxcape should always remain switched on. If you ever need to turn it off, then make sure you place it within its boundary area before you
TM
switching it back on again.
• Should your Landxcape stop operating, simply restart it and operate it as you normally would.
TM
NOTE: Please refer to the Owner's Manual for more information.
Setting
Please refer to Owner's Manual "4.3 Setting".
App
Please refer to Owner's Manual "5. App".
12
Status
TM
is fully charged.
TM
is auto charging.
" is displayed, please refer to "Error Messages" in Owner's Manual for solutions.
4. Press then to send Landxcape
Landxcape will follow the boundary wire to the charging base.
TM
When Landxcape touchs the boundary wire, ultrasonic function * turns
TM
off automatically (only for specific model, please check Technical Data &
Declaration of Conformity).
* With the ultrasonic function, your Landxcape
round/avoid the obstacles by using ultrasonic sensor.
5. Fine tune the outline shape of the boundary wire if necessary.
NOTE: If the boundary wire is broken during the testing or you need to
extend the boundary wire, please refer to "Joining the Boundary Wire"
in Owner's Manual for instructions.
Check the status of the LED light indicator on the charging base to make
sure the connection is OK.
If the verification test is completed smoothly, you can start mowing by
pressing then .
If there is any problem during verification test, please refer to "Owner's
manual-Troubleshooting".
Confirm that the power cord is connected properly to the charger and that
the charger is connected to a suitable power supply.
/
Confirm that there are no breaks in the boundary wire.
Check that the boundary wire has been connected correctly to the
charging base.
Confirm that there are no breaks in the boundary wire.
/
" will be displayed.
TM back to the charging base.
has the ability to get
TM
Action
EN