BOMANN KA 201 CB Bedienungsanleitung Seite 31

10 Mains plug
11 Cup shelf (removable)
12 Cup
Instructions
Placement
• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot tip
over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Electric Connection
1. Set the power switch (7) to "O", otherwise the appliance
may accidentally switch on.
2. Ensure that your mains power corresponds with the specifi-
cations of the appliance. The specifications are printed on
the type label.
3. Connect the mains cable to a properly installed and earthed
wall outlet.
Operation
Before brewing coffee for the first time, operate the appliance
twice with clean water only and without coffee powder. This
removes dust, which may have collected during transport.
Proceed as described under "Operation".
Operation
1. Ensure that the power switch (7) is set to "O".
2. Fold open the water tank lid.
3. Fill the water tank with cold water.
CAUTION:
Do not overfill the tank! Do not fill it above the MAX mark.
4. Push the water outlet to the side so that you can take
out the filter. Then pull the permanent filter out. Fill not
more than 4 g of coffee powder into the permanent filter,
otherwise there is a danger that it will overflow. Reinsert the
permanent filter. Push the spout back over the filter.
WARNING:
• Before cleaning, always remove the mains plug and wait until the
device has cooled down.
• Do not immerse the device in water. Otherwise this might result in
an electric shock or fire.
5. Place the cup on the tray and close the lid of the water
tank.
6. Plug the mains plug into a tested plug socket.
7. Position the switch in position "I". If the power indicator
lamp does not light up, press the start button . The brew-
ing is started.
NOTE:
• The power indicator lamp lights up.
• The brewing process lasts approximately 3-4 minutes.
• Approx. 15 seconds after the end of the brewing
process, the appliance automatically switches off.
The power indicator lamp goes out.
• You can interrupt the brewing process at any time by
setting the power switch (7) to "O".
8. Always set the power switch to "O" to turn the appliance off.
WARNING:
If you would like to make another cup of coffee immedi-
ately, switch the device off. Allow it to cool down with the
water tank open in order to prevent hot water splashing
out when the machine is refilled.
NOTE:
The appliance can only be switched on again with the
start button
1 minute.
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acidbased de-scaler.
• Follow the recommended instructions for use.
• Place the cup or other suitable vessel onto the cup shelf.
WARNING:
• Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
• Do not use any coffee powder!
• Do not use this water for consumption.
Cleaning
after a cool-down phase of approx.
De-scaling
31