Beko WTV8737XSN1 Bedienungsanleitung Seite 26

C
To use the HomeWhiz function, the app must be installed on your smart device and your washing machine must be paired to
your smart device via bluetooth. If your washing machine is not paired to your smart device it works as an appliance which
does not have a HomeWhiz feature.
Your product will operate as paired to your smart device via bluetooth. The controls made by means of the application will be enabled
through this pairing; therefore the bluetooth signal strength between the appliance and the smart device must be adequate.
Please visit www.homewhiz.com to see the Android and iOS versions supported by the HomeWhiz application.
A
WARNING:
manual apply to the remote operation through HomeWhiz function as well.
4.3.15.1 HomeWhiz Setup
In order for the application to run, a connection between your appliance and the HomeWhiz Application must
be established. For this connection to be established you must follow the steps below for setup procedure on
both the appliance and the HomeWhiz Application.
• If you are adding an appliance for the first time, tap „Add/Remove Appliance" button on the HomeWhiz
Application. After this step tap „Tap here to setup a new appliance". Follow steps below as well as steps in the
Homewhiz Application to perform the setup.
To start the setup, make sure that your machine is turned off. Press and hold the Temperature button and the
•
Remote Control Function button simultaneously for 3 seconds to switch your machine to HomeWhiz setup mode.
• When the appliance is in HomeWhiz setup mode, you will see an animation on the display and the
bluetooth icon will flash until your machine gets paired with smart device. Only programme knob will be active
in this mode. Other buttons will be inactive.
On the screen you see on the app, select the washing machine and press next.
•
• Proceed reading the on-screen instructions until HomeWhiz asks you about the product you wish to
connect to your smart device.
• If your washing machine successfully paires with your device, your display will automatically turn on in the
normal mode and the bluetooth icon will remain on as you hear a setup successful melody from the appliance.
• Return to the HomeWhiz application and wait until the setup is complete. When setup is complete, give your
washing machine a name. Now, you can tap and see the product you have added in the HomeWhiz Aplication.
C
If you cannot successfully perform the setup within 5 minutes, your washing machine will turn off automatically. In this case,
you will have to start over the setup procedure. If the problem persists contact the Authorised Service Agent.
You can use your washing machine with more than one smart device. To do this, download the HomeWhiz app on the other
smart device as well. When you launch the app, you will need to log in with the account you previously created and paired your
washing machine. Otherwise, please read "Setting up a washing machine that is connected to someone else's account".
A
WARNING:
HomeWhiz application will not let you finish the setup procedure successfully. Please contact your internet service provider
if you are having problems with your internet connection.
C
26 / EN
All the safety measures described in
You need internet connection on your smart device to proceed with HomeWhiz setup. Otherwise, the
HomeWhiz Application may require you to type the product number shown on the product
label. You can find the product label inside of the appliance door. The product number will be
shown on the label.
"GENERAL SAFETY INSTRUCTIONS"
section of your user
Washing Machine / User's Manual