Remote Control - HQ Power HQLE10061 Bedienungsanleitung

• When all devices have the same address, all the units will "listen" to the control signal on
one particular channel. In other words: changing the settings of one channel will affect all
devices simultaneously. If you set individual addresses, each device will "listen" to a
separate channel number. Changing the settings of one channel will only affect the device
in question.
Refer to page 3 of this manual for the DMX channel values.
5.6

Remote Control

Black Out
Press this button to black out the current active mode. Press again to return.
Auto
1. Press <AUTO> to enable the auto mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <AUTO> to disable.
Sound
1. Press <SOUND> to enable the sound mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <SOUND> to disable.
Strobe
1. Press <STROBE> to enable the strobe mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <STROBE> to disable.
Speed
1. Press <SPEED>.
2. Press <+> or <-> to adjust the programme speed.
Sensitivity
1. Press <SENSITIVITY>.
2. Press <+> or <-> to adjust the microphone sensitivity.
DMX/%
Allows you to activate/de-activate the DMX mode.
Manual
1. Press <MANUAL>.
2. Press <R>, <G> <B> or <W> to select your colour.
3. Press <+> or <-> to select the static colours.
1-9
Press <1> to <9> to adjust the colour intensity.
V. 01 – 07/12/2020
HQLE10061
10 ©Velleman nv