Assembly Instruction - profi-pumpe WASSERGEFLÜSTER Bedienungsanleitung

3. ASSEMBLY INSTRUCTIONS
l Unpack all the water fountain
components from the packaging
and lie on a flat surface.
l Connect the pump to the rubber
tube. Make sure the tube is pro-
perly connected and is not kinked.
l Connect led (preassembly to
fountain body) to cable connector
one by one.
l Connect cable connector to fe-
male cord from pump body.
l Install fountain top on the base, en-
sure it is stable before continuing.
l Connect pump cord to adapter.
l Fill clean water to the reservoir.
Note: Destilled water is recomended to reduce mineral deposits and bacteria build-up.
l Insert the plug into the power socket. If installed correctly water will start to flow from the
feature.
Please note, due to the shape of the slate, some water splashing out of the fountain
is inevitable in the first few seconds.
When all connections are complete, place
the pump at the bottom of the fountain.
Route the power cable to the
outside.
Power
cable
LED
cable
Water-
hose
Adapter
Hose
Pump
Fill the fountain with water. The pump must
be completely submerged in water, other-
wise the pump will be damaged.
English 3
LED
Cable
connector