Using The Product; Handle Assembly - Timberpro WBC 520 Bedienungsanleitung

5. FOR SAFE OPERATION
d. It is recommended that the legs and feet are fully
protected, to protect them from flying objects during
the operation.
4. Check the entire machine for loose/missing parts (nuts,
bolts, screws, etc.). Tighten/ replace before using the
machine. DO NOT use accessories with this machine
other than those recommended and supplied by the
manufacturer. Otherwise it will result in serious injuries
to the user or bystanders as well as damage to the
machine.
WARNING
NEVER use the machine with a metal saw blade
attachment, IT IS STRICTLY FORBIDDEN
BIDDEN
IMPORTANT
1. Keep the handles free of oil and fuel.
2. ALWAYS use the correct handles.
3. DO NOT smoke when mixing fuel or when filling the
tank.
4. DO NOT mix fuel in an enclosed area or near open
fire, flames or heat sources.
5. Make sure there is sufficient ventilation.
6. Mix and store the fuel mixture in a correctly marked
6. SET UP

HANDLE ASSEMBLY

1. Place the handle in the provided bracket and fix it with
the fixing bolts
(Please skip this step if the handle has been connected
with the bracket.)
container, which is allowed by local regulations.

USING THE PRODUCT

1. During and after use the engine and exhaust will be
very HOT you must keep all parts of your body and
clothing including all combustible materials clear of
the engine and exhaust.
2. DO NOT use the machine during or after rain, snow
or sleet. The floor will become slippery. DO NOT use the
machine on a slope or uneven ground or when there is a
chance of slipping or losing stability.
3. If you trip or fall whilst the machine is in use you MUST
immediately release the throttle, and turn off the ignition
switch.
4. If you hit any obstacles you must stop the machine
and remove the spark plug connector so that you can
inspect the machine. IF the machine is damaged in any
way you MUST get it repaired before restarting it.
5. DO NOT use a damaged machine or a machine with
a dent, cracked or damaged trimmer head.
6. If any trimmed materials get tangled in the nylon cord
you MUST stop the machine and remove the spark plug
connector . Only then can you clear any blockages.
7. DO not use the machine for trimming trees.
2. Take the 3 fixing bolts from the tool kit bag.
GB 06