Basic Parameters; Setting Temperature, Co; And High-Limit Temperature Alarm - Phcbi MCO-170M Bedienungsanleitung

BASIC PARAMETERS

Setting temperature, CO

Use the following procedure to set the chamber temperature, the CO
temperature of the high-limit temperature alarm for normal operation. The incubator uses these settings
automatically after the power is switched on.
Go to the Stand-by Setting screen (Menu
and enter each parameter. Press "Apply" to save
the entered values.
Parameter settings
• Temperature: Set value of chamber temperature. Settable range: 0.0
• CO Density: Set value of chamber CO
2
(OFF). If not necessary to set, slide to OFF, or enter 0.0.
• O Density: Set value of chamber O
2
setting: 20.0 % (OFF). If not necessary to set, slide to OFF, or enter 20.0.
• High Limit: The high-limit temperature alarm is different from the automatic set temperature alarm
(page 41), and is independent of it. It is activated if the chamber temperature exceeds the temperature set.
Settable range: 20.0
Notes:
• When changing the set temperature from less than 45.0
the CO sensor and O
2
Message display field, and "--.-" is displayed in the Present CO
density display field. After 15 minutes in the shortest, the incubator returns to the normal operation.
• When operating the incubator for the first time, or after not using it for an extended period, set the
chamber temperature to the desired temperature, set the CO
Operate the incubator for at least 4 hours until the chamber temperature, the CO
sensor are stable. Then change the setting to the desired CO
• Set the high-limit temperature alarm parameter when the chamber temperature is stable at the set value.
• Set the high-limit temperature alarm to at least 1

and high-limit temperature alarm

Set)
density. Settable range: 0.0 %–20.0 %; factory setting: 0.0 %
2
density. Settable range: 1.0 %–18.0 % and 22.0 %–80.0 %; factory
2
o o
C–53.0 C; factory setting: 53.0
sensor. During readjusting, "Status: Gas sensor initializing" is displayed in the
2
density, O
2
density, the O
2
o
C–50.0
o
C.
o o
C to 45.0 C or higher, the incubator readjusts
density display field and the Present O
2
density to 0 % and the O
2
density and O
2
o
C higher than the temperature set for the chamber.
density,
2
density, and the
2
o
C; factory setting: 37.0
density to 0 %.
2
sensor, and the O
2
density.
2
o
C.
2
2
37