Connecting A Co Gas Cylinder - Phcbi MCO-170M Bedienungsanleitung

INSTALLATION
Connecting a CO
Before connecting a CO
1. Get a CO gas cylinder ready and install an optional gas regulator MCO-010R.
2
Notes:
• Use a liquefied-CO
• When MCO-010R is not available, install a gas regulator rated at 25 MPa(G) (250 kgf/cm
3600 psi(G)) for the primary side, and 0.25 MPa(G) (2.5 kgf/cm
2. Using the gas tube provided, connect the
connecting port A for the CO
regulator of the CO
Notes:
• By using two tube bands provided, connect the gas tube tightly to prevent it from coming off.
• Make sure that the gas tube is not folded.
• If the CO gas is supplied to multiple O
2
formed in the gas regulator. The gas regulator safety valve will operate, and there may be an explosive
sound.
3. After connecting the gas tube, make sure that no gas is leaking (ex. by using a gas leak detector
spray).
4. Set the CO gas on the secondary side to 0.03 MPa(G)–0.1 MPa(G) (0.3 kgf/cm
2
4.4 psi(G)–14.5 psi(G)) for gas injection.
Recommended pressure: 0.03 MPa(G) (0.3 kgf/cm
Note: As the pressure increases, the CO
cause gas supply lines inside the incubator to come loose, which may result in gas poisoning or oxygen
deprivation due to leaking gas. If gas lines come loose, the incubator must be repaired.
5. When there is no CO
cylinder.
Note: When the optional gas auto-changer MCO-21GC is installed, it switches the empty CO
line to the other automatically. Refer to pages 65–66.
Note: The gas lines connected to the incubator will degrade over time. If any deterioration or abnormalities
are found during inspection, replace the lines immediately.
22
gas cylinder
2
gas cylinder, read the precautions for safe operation on pages 5–9.
2
gas cylinder (at least 99.5 % pure). The siphon (dip tube) type cannot be used.
2
gas pipe and the gas
2
gas cylinder.
2
/CO
2
gas density variation will increase. Excessive pressure may
2
gas left and the CO
2
2
(G), 36 psi(G)) for the secondary side.
Lower right side
Connecting port A for CO
incubators from a single gas cylinder, a CO
2
2
(G), 4.4 psi(G)).
gas empty alarm is activated, replace the empty gas
2
2
(G),
gas pipe
2
solid will be
2
2 2
(G)–1 kgf/cm (G),
gas supply
2