Disposal And Recycling; Troubleshooting - KRAFT WERKZEUGE 7110 Originalbetriebsanleitung

Storage
m Important!
Pull out the mains plug and ventilate the equip-
ment and all connected pneumatic tools. Switch
off the compressor and make sure that it is se-
cured in such a way that it cannot be started up
again by any unauthorized person.
m Important!
Store the compressor only in a dry location
which is not accessible to unauthorized persons.
Always store upright, never tilted!
Storage power cord, hose and accessories (Fig. 2)
• The power cord can be stored sideways of the
compressor.
• The air hose can be stored in the tool cmpartment.
Transport
• The unit can be transported with the handle (1)
(fig. 5).

Disposal and recycling

The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defec-
tive components must be disposed of as special
waste. Ask your
dealer or your local council.

Troubleshooting

Fault Possible cause
The compressor does • No supply voltage.
not start.
• Insuffi cient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
The compressor • The non-return valve leaks.
starts but there is no
pressure. • The seals are damaged.
The compressor starts, • The hose connections have a leak.
pressure is shown on
the pressure gauge, • A quick-lock coupling has a leak.
but the tools do not
start.
18 18 GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequenc-
es for the environment and human health due to po-
tentially hazardous substances that are often con-
tained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Remedy
• No supply voltage.
• Insuffi cient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
• The non-return valve must be replaced by a
specialist.
• The seals are damaged.
• The hose connections have a leak.
• A quick-lock coupling has a leak.