Device Description - KRAFT WERKZEUGE 7110 Originalbetriebsanleitung

Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
we hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety notices contained in this
operating manual and the particular instructions for
your country, the generally recognised technical reg-
ulations for the operation of identical devices must
be complied with.

Device description

1. Transport handle
2. ON/OFF switch
3. Compressor housing
4. Quick-lock coupling
5. Pressure hose
6. Power cord
Breather valve
7.
Hose with valve adapter
8.
Compressed air gun with pressure gauge
9.
A Universal adapter, for valves with diameter ca.
6 mm
Universal adapter, for valves with diameter ca.
B
9 mm
Adapter for H, J, K
C
Blow-out adapter
D
E Valve adapter, e.g. For bicycle valves
F Ball needle
G Tyre pressure gauge
Deflating adapter
H
Screw-on valve adapter
J
Universal adapter
K
Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
• Compressor
• Universal adapter, for valves with diameter ca. 6
mm
• Universal adapter, for valves with diameter ca. 9
mm
• Adapter for H, J, K
• Blow-out adapter
• Valve adapter, e.g. For bicycle valves
• Ball needle
• Tyre pressure gauge
• Deflating adapter
• Screw-on valve adapter
• Universal adapter
• Operating manual
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
GB 13 13