Touchscreen - Intenso 8“ INTENSOTAB Bedienungsanleitung

3.) If the device is connected with a computer, you can open the status bar by pressing, holding and
,
pulling down to disable the USB Memory.

To disable the memory, select "Disable USB Memory" and confirm again in the rising menu "Turn
off USB Storage".

Select on the computer the function "Safely Remove"
computer.
Note: The pre-installed applications and the Android™ operating system take up some of the existing internal memory – about 1 GB of
space is occupied. For this reason, you cannot dispose of the entire internal memory.

8.) Touchscreen

This device is controlled via a touchscreen. You can easily launch applications by gently tapping your
fingers on the touchscreen, enter text on the virtual keyboard and switch between home screens by
swiping in either direction. Furthermore, on the right side four sensor buttons are available (Search,
Home screen, Menu and Back). Simply tap briefly on the desired sensor button to perform the
function.
Please remove the protective film from the display before using the device.
The touchscreen detects small electrical charges, as for example emitted by human fingers, and thus
determines the input point.
Use for input ideally your fingertips. Operation with a pen or other sharp objects is not possible.
The touchscreen should not be exposed to water or other electrical devices to avoid malfunctions and
permanent defects.
Notes
a. If the touchscreen is not operated for two minutes, the device goes into standby mode. Briefly press the on / off button to switch to
active mode.
b. To prevent unwanted input, a lock mode is activated automatically. Please unlock the keypad on the touchscreen by simply
dragging the lock icon from the bottom to the top of the screen. The device will now switch to the home screen.
You can rotate the device in all directions. It has a sensor that directs the display automatically.
Please pull the status bar down to disable the USB memory.
EN - 6
to disconnect the device from the