Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Technical Product Information BLANCOPERISCOPE-S-F HD
Parts List BLANCOPERISCOPE-S-F HD
1 Jet regulator
2 Hose spray
3 Non-return valve
5 Spray hose
4 Seal spray hose
17 Seal spray hose
7 Spout
6 Fitting
8 Plastic nut for spout
9 Pump
10 Ring
11 Weight
12 Seal flexi-hose
13 Flexi-hose
14 Extensible plastic tube
15 Cable tie
16 Plastic nut
18 Base
19 Body
20 Cartridge
21 Cartridge lock nut
22 Lever body
23 Screw of the lever
24 O-ring
25 Lever
26 Retaining ring
Technical Data
Fields of application
• Can be installed in front of a window
• Folds down in any position but remains fully
functional
• Pressurised hot water tank
• Thermally-controlled instantaneous water heater
• Hydraulically controlled instantaneous water
heater
It is not possible to operate the tap with low-
pressure hot water tanks (open boiler).
Operating pressure
• Min.
• Max.
• A pressure reducer must be installed above
5 bar.
Temperature
• Max. (warm water inlet)
• Recommended (energy saving) 60° C
• Water connection: hot-left / cold-right
Note
Pressure differences of more than 3 bar between
cold and hot water connection must be avoided
since, otherwise, the mixing ratio of hot and cold
4
�
�
�
�
��
water can deviate considerably from the lever
position.
0,5 bar
10 bar
Before installation and commissioning
Before the fitting is installed, the intake pipes must
be thoroughly flushed so that no swarf, bits of
hemp or other contaminants can enter the fitting.
70° C
Foreign bodies can enter the fitting through pipes
which have not been flushed, or the water system
in general, and damage the ceramic disks and
O-rings. The installation of a dirt filter is recom-
mended in all cases.
Before commissioning the fitting, unscrew the jet
regulator and flush well.
�
��
��
�
��
�
��
�
��
�
�
��
��
��
��
��
��
��
��
��
��
��
Werbung
