Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the other hand. The hose must not be bent. Do not step on it, as this
will lead to formation of droplets.
The movement speed of the spray gun depends on the setting of the
paint flow regulator (8). With little paint, move the spray gun slowly.
With plenty of paint move it faster. Do not spray in an arc on the sur-
face and do not interrupt spraying as this will lead to uneven or too little
paint distribution onto the surface. The general recommended spraying
distance is about 20 cm.
If the finish is too dry, use the air flow regulator (10) to reduce the air
supply. Turn the air regulator steplessly clockwise to reduce the max.
possible air pressure.
If the finish is too wet, reduce the amount of paint with the paint flow
regulator (8).
If the atomisation is too coarse, increase the intake air pressure with
the air flow regulator (10). If the atomisation is too fine, reduce the
intake air pressure.
Always keep the spray gun in a constant distance to the surface to be
sprayed. Move the spray gun evenly and in parallel lanes from one side
to the other.
Start spraying openings and corners of the object. If necessary, take a
short break after each spraying process, so the paint may evaporate.
Each lane should overlap to at least 50 %. Move the gun evenly and
always horizontal to the object. Always work from top to bottom. Move
the spray gun over the edges of the object so that the edges get
enough paint.
If you do not use the spray gun for a short time, hang it on the suspen-
sion eye (7). Turn off the air supply and release the pressure.
Check the paintwork on all sides, before cleaning the spray gun. After
work empty the paint container into an appropriate bin. Properly dis-
pose of coating material that is no longer needed.
Recently treated surfaces must not be exposed to direct sunlight, to
very high or low temperatures, wind, dust, water or rain.
Operation
27
Werbung
Inhaltsverzeichnis
