Installation; Attaching The Additional Handle; Attaching The Polishing Disk; Use - Formula 1 PM200 Originalbetriebsanleitung

EN
Ins tallation
Caution!
Remove the battery pack prior to assembly.

Attaching the additional handle

1. Place the additional handle on the device.
2. Screw the additional handle in place with the
hexagon key.

Attaching the polishing disk

1. Press and hold the axle lock button.
2. Screw the polishing disk onto the spindle of
the polishing disk holder.

Use

Charging the storage battery

•
The storage battery should be fully charged
prior to first use.
•
Regularly check the charge of the battery pack
when stored for extended periods.
•
Fully charge the battery every month, even if
the device has not been used.
1. Connect the mains plug of the charger to a
230 V mains socket.
2. Insert the battery pack in the charger until the
battery pack clicks into place.
3. The battery will now start charging. The LEDs
on the charger indicate the current status.
Green LED Red LED
steady light steady light
flashing steady light
off flashing
flashing alternately
4. When the battery pack is fully charged, press
the release button on the battery pack and
remove the battery pack from the charger.
16 f1.mts-gruppe.com
Meaning
Battery pack fully
charged.
Battery pack charging.
Battery pack too hot.
Battery pack defective.

Using the accessories

Warning!
Always remove the battery pack before attaching
or removing accessories.
Set the device on a level surface with the polish-
ing disk facing up.
Application
Use the polishing sponge to apply the polish.
Ensure the polishing sponge is clean and always
fixed in the middle of the polishing disk.
•
4 cm polishing sponge: For applying paint care
products, low speed.

Polishing

To polish, remove the polishing sponge and use
the polishing bonnet. Ensure the polishing bonnet
is clean and pull the polishing bonnet taut and
evenly over the polishing disk.
•
Microfibre polishing bonnet: suitable for paint
cleaning products, low to medium speed.
•
Cotton polishing bonnet: suitable for high-gloss
finish, low to high speed.

Switching the polisher on/off

1. Insert the battery pack in the device until the
battery pack clicks into place.
2. Hold the switch lock and press the on/off
switch to switch the device on.
3. Release the on/off switch to stop the device.
4. After using the device, press the battery re-
lease button and remove the battery pack.

Speed control

This device is equipped with control electronics
which maintains a consistent speed when differ-
ent forces are applied. The speed can be set with
the wheel on the top of the handle. The wheel is
marked „1, 2, 3, 4, 5, 6". For maximum power, set
the wheel to setting „6".
Polishing
•
Observe the manufacturer instructions when
using waxes and polishes.
•
Always ensure all polishing attachments are
clean. The polishing disk must always be
applied flat to the painted surface. Corners
and edges should be polished by hand, as for
untrained individuals may remove paint or paint
may flake.
•
For optimal results, we recommend NIGRIN
paint care products.