General Information - Gazzini 10030234 Original-Gebrauchsanleitung

Art. No. 10039620
2 3
1x Bar-end mirror
1
1x clamping sleeve (large and small) and
2
threaded cone

2 | General information

2.1 | Reading and keeping the instructions for use
These instructions for use apply exclusively to the aforementioned gazzini Bar-End
Mirrors (for short: mirrors). They contain important information on installation,
safety and the warranty. Read these instructions carefully, in particular the safety
instructions, before installing the mirror. Failure to follow the instructions can result
in damage to the mirror itself or to your motorcycle, make it less safe to ride on the
road, and possibly cause consequential damage. Keep these instructions for future
reference. If you pass the mirror on to a third party, you must also hand over these
instructions. The instructions for use are based on the standards and regulations
applicable in the European Union and refl ect current state-of-the-art technology. If
abroad, you should also observe any country-specifi c guidelines and laws.
12
1
4
1x countersunk screw with hexagon
3
socket head ISO 10642 M6 x 60 A2
1x cap (self-adhesive)
4
2.2 | Explanation of symbols
The following symbols and signal words are used in these instructions.
This symbol/signal word indicates a hazard with a
WARNING! medium risk level which, if not avoided, may result in
death or serious injury.
This symbol/signal word indicates a hazard with a low
CAUTION! risk level which, if not avoided, may result in minor or
moderate injury.
IMPORTANT! This signal word warns of possible material damage.
This symbol indicates useful additional information
about assembly or usage.
This symbol indicates that the packaging and the
product itself can be recycled.
3 | Safety
3.1 | Intended use
The gazzini Bar-End Mirror is used as a replacement for a faulty original mirror or
for enhancing the look of the motorcycle. The mirror is designed for motorbike
handlebars with an outside diameter of 22.2 mm (metric) or 25.4 mm (imperial) and
an inner diameter of 13.5 - 22 mm. The ends of the handlebar must be open, i.e. they
must not be blocked by thread inserts or similar. To ensure that the components
are used correctly and safely on your motorcycle, it is imperative that you adhere to
the specifications in your vehicle operating instructions and the stipulations of the
vehicle manufacturer. The gazzini Mirror must only be used as described in these
instructions. Any other use is considered improper use and can result in material
damage. The manufacturer and supplier accept no liability for damage caused by
improper or incorrect use.
13