Werbung
Verfügbare Sprachen
Verfügbare Sprachen
button to confirm your setting
The Minute display of the Alarm time starts to flash,Use the "▲" and "▼buttons to set the required minute. Press
"ALARM" button to confirm your setting and to end the setting procedure.
To activate or deactivate the daily alarms, in the alarm mode, press "UP" button to switch alarm function.
F.Y.I.:
After 7 seconds without pressing any button the clock switches automatically from setting mode to Normal clock mode.
The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm will be
repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm signal is heard.
Automatic SNOOZE function:
To activate the automatic snooze function: While the alarm is sounding, press the "SNOOZE" button to activate the
snooze function. When the snooze function is activated, the Alarm symbol appears in the display.
This operation moves the alarm back by 5 minutes and the alarm will restart at this time.
The snooze function can be interrupted by pressing any button and can be repeated up to seven times.
°C/°F temperature display:
The temperature is displayed either in °C or °F. Briefly pressing the "▼ "button allows you to switch between the
individual models.
Reception of the Radio signal:
The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of new fresh batteries.
The radio mast icon starts to flash.
At 1:00 am, the clock automatically carries out the synchronization procedure with the DCF signal to correct any
deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon disappears from the
display), the system will automatically attempt another synchronization at the next full one hour. This procedure is
repeated automatically up to total 5 times.
To start manual DCF signal reception, press the "WAVE" button. If no signals received within 7 minutes, then the DCF
signal search stops (the radio mast icon disappears) and start again at the next full one hour.
During RC reception，to stop searching radio signal, Press and hold the "WAVE" button for two seconds.
F.Y.I.:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer
monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme circumstances,
place the system close to the window.
WS 8006 Manual
Werbung
