Technoline WS 8006 Bedienungsanleitung Seite 4

Technical data:
 Radio controlled clock
 Manual time setting
 Time zone setting: -12/+12 hour difference
 Continuous calendar up to year 2099
 Temperature display in °C or °F
 Two daily alarms
 Time in optional 12/24 hour format
 Snooze function
 Thermometer measurement range: 0°C (32°F) ~ 50°C (122°F) (calibration time: 30 seconds)
 Hygrometer measurement range: 20% ~ 95% RH. Separate display of indoor use
 Battery: 2 x 1.5V "AA" size (not included)
Important information
Initial operation:
 Open the battery compartment on the rear side of the receiver and insert the batteries. Pay attention to observe the
correct polarity. Close the battery compartment.
 When you insert the batteries, all the icons on the LCD display will briefly light up for 3 seconds, and you will hear a beep
tone, and detect indoor temperature & humidity.
 The clock automatically starts the DCF signal search after 7 minutes. The radio mast icon starts to flash.
Manual time setting:
 Press and hold down the "SET" button for 2 seconds, the 24 display starts to flash. Now use "▲" and "▼" buttons to set
the correct 12/24 time format.
 Press "SET" to confirm your setting, the Hour display starts to flash. Now use "▲" and "▼"buttons to set the correct
hour.
 Press "SET" to confirm your setting, the Minute display starts to flash. Now use "▲" and "▼"buttons to set the correct
minute.
 Press "SET" to confirm your setting, the 2008 display starts to flash. Now use "▲" and "▼"buttons to set the correct year.
 Press "SET" to confirm your setting, the Month 1 displays starts to flash. Now use "▲" and "▼"buttons to set the correct
month.
 Press "SET" to confirm your setting, the Date 1 start to flash, Now use" ▲" and "▼" buttons to set a correct date.
 Press "SET" to confirm your setting and to end the setting procedures, enter the clock mode.
F.Y.I.:
 To start manual time setting, DCF radio reception must be disabled. Press and hold the "Wave" button for 2 seconds and
the radio symbol goes off.
 After 7 seconds without pressing any button, the clock switches automatically from Set Mode to Normal Time Mode.
 There are 7 languages of Weekday: English, Italian, French, Netherlands, Spanish, Danish, and German.
Setting the daily alarms:
This clock possesses one daily alarms. To view the set alarm times, press the "ALARM" button briefly, the display
switches from the clock to Alarm. If you press the button again, the clock switches back to the normal time display.
Proceed as follows to set the daily alarms:
 Press and hold down the "ALARM" button for two seconds until alarm time and the flashing icon are displayed.
 The Hour display of the Alarm time starts to flash. Use the "▲" and "▼"buttons to set the required hour. Press "ALARM"
WS 8006 Manual