Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
VC-CJS11
Power Bank Quick Start
System 800 A
Item No. 2347244
Intended use
The product is a powerbank, and quick start system
for petrol and diesel engines. It has an integrated
LED light.
Ingress protection
The product has an IP66 ingress protection
rating and is protected against dust and water
sprayed from any direction. It is only protected
when the sockets cover is closed.
Contact with moisture must be avoided under
all circumstances if the sockets cover is open.
For safety and approval purposes, you must not re-
build and/or modify this product. If you use the prod-
uct for purposes other than those described above,
the product may be damaged. In addition, improper
use can result in short circuits, fires, electric shocks
or other hazards. Read the instructions carefully and
store them in a safe place. Make this product avail-
able to third parties only together with its operating
instructions.
This product complies with the statutory national and
European requirements. All company names and
product names are trademarks of their respective
owners. All rights reserved.
Delivery content
•
Product
•
"Smart" starter cables
•
USB charging cable
•
Carry case
•
Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in the
triangle is used if there is a risk to your
health, e.g. due to an electric shock.
The symbol with the exclamation mark in
the triangle is used to indicate important
information in these operating instruc-
tions. Always read this information care-
fully.
The arrow symbol indicates special in-
formation and advice on operation.
Read the operating instructions care-
fully.
Safety instructions
Read the operating instructions
carefully and especially observe
the safety information. If you do not
follow the safety instructions and
information on proper handling in
this manual, we assume no liability
for any resulting personal injury or
damage to property. Such cases will
invalidate the warranty/guarantee.
a) General information
•
The device is not a toy. Keep it out of the reach
of children and pets.
•
Do not leave packaging material lying around
carelessly. This may become dangerous playing
material for children.
•
Protect the appliance from extreme tempera-
tures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, steam and solvents.
•
Do not place the product under any mechanical
stress.
•
If it is no longer possible to operate the product
safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer
be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor
ambient conditions or
- has been subjected to any serious transport-
related stresses.
•
Please handle the product carefully. Jolts, im-
pacts or a fall even from a low height can dam-
age the product.
•
Consult an expert when in doubt about the op-
eration, safety or connection of the appliance.
•
Maintenance, modifications and repairs must
only be completed by a technician or an author-
ised repair centre.
•
If you have questions which remain unanswered
by these operating instructions, contact our tech-
nical support service or other technical person-
nel.
b) Connected devices
•
Also observe the safety and operating instruc-
tions of any other devices which are connected
to the product.
c) LED light
Attention, LED light:
•
Do not look directly into the LED light!
•
Do not look into the beam directly or with optical
instruments!
d) (Rechargeable) batteries
•
The rechargeable batteries are permanently built
into the product and cannot be replaced.
•
Never damage rechargeable batteries. Damag-
ing the casing of rechargeable batteries might
cause an explosion or a fire!
•
Never short-circuit the contacts of the recharge-
able batteries. Do not throw the battery or the
product into fire. There is a danger of fire and
explosion!
•
Charge the rechargeable batteries regularly,
even if you do are not using the product. Due to
the rechargeable battery technology being used,
you do not need to discharge the rechargeable
battery first.
•
Never charge the rechargeable batteries of the
product unattended.
•
When charging, place the product on a surface
that is not heat-sensitive. It is normal that a cer-
tain amount of heat is generated during charg-
ing.
e) Product
•
Explosion Hazard! Do NOT use this product
where flammable fumes or gases may be pre-
sent, e.g. Petrol refueling station.
Operating elements
For the ingress protection rating to be effective, the sockets cover must be properly closed.
a) Product
2
1
3
4
5
1 Battery level indicators
4 Output: USB-A charging
5 Input: MicroUSB charging
2 Power button
6 LED light
3 Starter cables socket
b) "Smart" starter cables
A
B
C
D
E
A Starter status indicator
C Force Start Button
B Starter cables plug
D Red starter clip (+)
Charge the product battery
Important
•
Do not charge the power bank using the USB-A ports on a computer. The current supplied by
these ports may not be sufficient, and may damage the computer.
•
Use a suitable power adaptor capable of delivering 5 V/DС 1.5 A.
•
To prolong the battery life it is recommended to fully charge the battey every 3 - 6 months.
•
Do not jump start the vehicle while charging the batteries!
•
The battery level indicators will indicate the level of charge:
(●= 25%, ●● = 50%, ●●● = 75%, ●●●● = 100%).
•
Short press the
button to check the battery level.
•
To recharge the battery, connect one end of the charging cable to a suitable power supply and the
other end to the microUSB charging port on the product.
- Battery level indicators flashing: charging in progress
- All four indicators constant on: fully charged.
Power bank
•
To use this product as a power bank you will need a suitable charging cable (not included).
•
Connect one end of the charging cable to your mobile device, and the other end to the USB-A charging
port on the product.
•
Press the
button to start charging.
LED light
1. Press and hold the
button (approx. 3 secs) to switch the LED ON/OFF.
2. Press the
button repeatedly to cycle through modes: constant ON → SOS → flashing → OFF
7
6
7 Sockets cover
E Black starter clip (-)
Werbung
Inhaltsverzeichnis
