For Installer; Installer Setup System Setup; 5�1 Optional Pcb Connectivity; 5�2 Zone & Sensor - Panasonic WH-SDC03H3E5-1 Bedienungsanleitung

Menus

For installer

Menu

5 Installer setup System setup

5.1
Optional PCB connectivity
To connect to the external PCB
required for servicing�
• If the external PCB is connected (optional), the system will have following additional functions:
Buffer tank connection and control over its function and temperature�
1
Control over 2 zones (including the swimming pool and the function to heat water in it)�
2
Solar function (the solar thermal panels connected to either the DHW (Domestic Hot Water) Tank or the Buffer Tank�
3
External compressor switch�
4
External error signal�
5
SG ready control�
6
Demand control�
7
Heat-Cool SW
8
5.2
Zone & Sensor
To select the sensors and to
select either 1 zone or 2 zone
system�
5.3
Heater capacity
To reduce the heater power if
unnecessary�*
3 kW / 6 kW / 9 kW
* Options of kW vary
depending on the model�
5.4
Anti freezing
To activate or deactivate the
water freeze prevention when
the system is OFF�
5.5
Tank connection
To connect tank to the system�
5.6
Buffer tank connection
To connect tank to the system
and if selected YES, to set
T temperature�
• The optional PCB
connectivity must be selected
YES to enable the function�
• If the optional PCB
connectivity is not selected,
the function will not appear
on the display�
14
Default Setting Setting Options / Display
No
Zone
• After selecting 1 or 2 zone system, proceed to
the selection of room or swimming pool�
• If the swimming pool is selected, the
temperature must be selected for
T temperature between 0 °C ~10 °C�
Sensor
* For room thermostat, there is a further
selection of external or internal�
3 kW / 6 kW / 9 kW
Yes
No
No
Yes
5 °C Set T for Buffer Tank