Installation; Operation - Polar GE579 Bedienungsanleitung

UK

Installation

Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
WARNING: When positioning the appliance,
ensure the supply cord is not trapped or
damaged.
WARNING: Do not locate multiple portable
socket-outlets or portable power supplies
at the rear of the appliance.
Reverse the Door
1. Disconnect the appliance from the power
supply.
2. The door is opened from left side originally.
3. Remove the 2 screw covers and screws on the
right top and keep for later use. Then remove
the door and right hinge.
Door
4. Remove the screw covers and screws on the
left top. Then pull out the locking plate.
4
GE579_ML_A5_v1_20210119.indb 4 GE579_ML_A5_v1_20210119.indb 4
Locking plate
5. Insert the left hinge (supplied) and secure with
the 2 screws. Then attach screw covers.
6. Remove the bottom spindle from the right foot
and fix it on the left foot.
7. Install the door correctly.
8. Fix the previously removed locking plate to
the right top with screws. Then attach screw
covers.
9. Now the door is opened from right side.

Operation

Controller
The controller is located
inside the cabinet.
The thermostat is graded
from High (warm) to
Low (cold).
Turn On
1. Set the thermostat to the desired setting.
2. Close the door of the appliance.
3. Connect the appliance to a mains power
supply.
Lock/Unlock the Door
Use the keys provided to lock/unlock the door.
To avoid contamination of drink, please
respect the following instructions:
• Opening the door for long periods can cause a
Hinge
significant increase of the temperature in the
compartments of the appliance.
• If the refrigerating appliance is left empty for
long periods, switch it off. Then defrost and
clean it thoroughly. Let it dry well and leave
the door open to prevent mould developing
within the appliance.
• Clean regularly surfaces that can come in
contact with drink and accessible drainage
systems.
2021/1/19 13:40 2021/1/19 13:40