Installation; Operation; Cleaning, Care & Maintenance - Polar GL001 Bedienungsanleitung

UK

Installation

1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. When positioning the appliance, maintain
a distance of 20cm (7 inches) between the
appliance and walls or other objects for
ventilation. Increase this distance if the
obstacle is a heat source.
4. Insert the slide-out shelf/shelves at the desired
levels and place the smaller shelf/shelves on
the floor of the appliance.
5. If necessary, adjust the screw feet of the
appliance to make it level.

Operation

Control Panel
The control panel is located below the doors on the
front of the appliance.
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
4
GL001-GL016_ML_A5_v5_170328.indb 4
Downloaded from www.Manualslib.com
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Cooling Light Defrost Light
manuals search engine
3. Turn the light switches On [I] or Off [O] as
desired.
Note: The Cooling Light is
illuminated when the appliance
is chilling the interior cabinet.
Set the Operating Temperature
1. Press the button. The display will flash.
2. Press the or buttons to display the
required temperature.
3. Press the button to store the temperature.
Manual Defrost
• POLAR Back Bar Chillers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
and button for 6 seconds.
• Automatic defrost cycles are every 6 hours and
last 20 minutes (factory defaults).
• To stop the Defrost press and hold the
button for 6 seconds.
Note: If a manual defrost is
started this resets the automatic
defrost timer. During defrost
periods the Defrost light is
illuminated.
Cleaning, Care &
Maintenance
Switch off and disconnect
from the power supply before
cleaning
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must
carry out repairs if required.
and
2017/3/28 11:33