Cleaning And Maintenance - Ribimex Babycen PRCEN018 Bedienungs- Und Wartungsanleitung

characteristics of the appliance, check the rating label on the appliance.
- Turn the appliance on using the ON/OFF switch located on the cover of the motor.
- Vacuum the ash directly from the stove using the metal tube.
- If the suction power decreases, turn the motor off using the switch and when the motor has
completely stopped, lift the lid.
- Shake and tap the pre-filter lightly to make most of the ash fall into the bin.
Remove first the pre-filter and then the filter from the respective housing.
- Wash the filters under a gentle jet of running water (fig.4) and at room temperature in order not to damage
them. Use a soft brush to remove the most stubborn residues. Do not use hot water otherwise the filter may
warp.
- Do not use detergents. Leave the filter to dry naturally before replacing it in its housing. Do not place it
close to hot sources of heat. Do not place it in direct sunlight.
- When the stove has been cleaned, the appliance and suction filter must then be cleaned as described above.
The cleaning operations should be done outdoors.
- After cleaning the filter, always check to make sure it is suitable for further use.
- Whenever signs of damage or breakage are noted, change the filter with the correct RIBIMEX original spare part:
Code PRCEN018/HEPA Hepa filter
Code PRCEN018/CF Pre-filter
These spare parts are available at all RIBIMEX dealers or wherever you purchased the product.
- PREFILTER SUPPLIED WITH THE EQUIPMENT:
Follow the instructions as indicated in the leaflet inside the package.

CLEANING AND MAINTENANCE

CAUTION: Before carrying out any cleaning or maintenance operation, the plug must always be
The container and the filter should be cleaned quite regularly to ensure the equipment works properly. The presence
of residue or dirt inside the filter or the metal tube can be the cause of unsatisfactory operation. In this case, it is
advisable to turn off the equipment, remove the plug from the socket and then clean the parts.
If these instructions are not followed, the guarantee will automatically become null and void.
Expendable parts subject to normal wear such as the HEPA filter and the pre-filter are not covered by warranty.
removed from the socket.
Fig. 4