Herunterladen Inhalt Inhalt Diese Seite drucken

Battery Installation - Orno ERATO AC Bedienungs- Und Montageanleitung

Drahtlose klingel
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

(4) Space for
name
Fig. 2a Transmitter (button) construction
Fig. 4 Login
The sound is released after pressing to the
center of the button.
The ringtone has 32 melodies to choose from. Briefly pressing the Melody Select / Pairing button (3) on the receiver will change the ringtone to
the next one in the cycle. To set the ringer volume, press the volume button (1) repeatedly on the receiver.
Declaration of conformity:
Orno-Logistic Sp. z o.o. declares that the OR-DB-AX-151 compatible with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following Internet address: www.orno.pl
RECEIVER CONSTRUCTION
(1) five-level volume control
(2) Ringtone selection /
Pairing
TRANSMITTER (BUTTON) CONSTRUCTION
(5) Protective roof

BATTERY INSTALLATION

Fig. 3 Battery installation in the button
SELECTION OF MELODY / VOLUME ADJUSTMENT
Fig. 2b Transmitter (button) construction
Pry up the cover with a flat screwdriver. (fig. 3)
1.
Fasten the protective roof to the wall with two screws in
2.
positions marked with arrows or with self-adhesive mounting
stickers. (fig. 3)
Insert the batteries into the receiver observing the correct
3.
polarity. (fig. 4)
Close the cover and mount the button on the protective roof.
4.
LOGIN
NOTE: After removing and installing the battery, the device should work
automatically because the receiver and transmitter are paired. If the doorbell
does not work properly or there are problems with coverage, use the
following steps:
1. Press and hold the Sound Select / Pairing button (2) until you hear the
"DING-DONG" sound.
2. Then press the bell button (4), you will hear the "DING" sound signal
which means that the devices have been paired.
3. You will hear the "DING DONG" sound indicating exit from login
mode.
RESET OF RECEIVER
1.
Disconnect the receiver from the 230V power supply.
2.
Press and hold the sound selection button.
3.
connect the receiver to the network with the button pressed.
4
(3) Power plug
Fig. 1 Receiver construction

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Or-db-ax-151

Inhaltsverzeichnis