Inhaltsverzeichnis
Werbung
Fig. 1
Fig. 2
RECEIVER CONSTRUCTION
Optical indication
TRANSMITTER CONSTRUCTION
Optical indication
Audible
indication
Audible +
optical
signalling
BATTERY INSTALLATION
LOGIN
5
Sound Select/pairing button
Volume
Sound playback
1.
Take off the transparent cover protecting the name card.
Then carefully undermine the grey cover with a flat
screwdriver.
2.
Fix the base plate to the wall using the two supplied
screws in the marked positions or using self-adhesive
mounting stickers.
3.
Insert the batteries into the receiver observing the correct
polarity.
4.
install the button on the base plate.
NOTE: After removing and installing the battery, the device should
work automatically because the receiver and transmitter are paired. If
the doorbell does not work properly or there are problems with
coverage, use the following steps:
Press and hold the Sound Select / Pairing button until you
1.
hear the "DING-DONG" sound.
Then press the bell button, you will hear the "DING" sound
2.
signal which means that the devices have been paired.
You will hear the "DING DONG" sound indicating exit from
3.
login mode.
Werbung
Inhaltsverzeichnis
