Initial Operation; General Guidelines - WMF Kult X Gebrauchsanweisung

The jug is not suitable for storing juice. Fresh juice should be consumed within 2
hours of juicing or be transferred into another container.

Initial operation

Clean all removable parts before operating it for the first time as described in the chapter „Cleaning
and Care". Ensure that you do not injure yourself on the sharp blades.
Make sure that the rotary knob is in position O.
Remove the required length of mains cable from the cable storage to the
rear of the appliance by pulling it out manually.
Note: The appliance has a Cable Assistant. The integrated cable storage
enables the mains cable to be easily stored in the appliance and pulled
out when necessary.
Place the juice tray in the appliance so that the juice spout sits in the
recess intended for this purpose.
Place the micro-strainer in the juice tray. Each time before using the
appliance, check if the micro-strainer is damaged. If you notice any
cracks or other damage, you must not use the appliance until the micro-
strainer has been replaced.
Ensure that you do not injure yourself on the sharp blades.
Insert the pulp container by tipping it gently forwards (1).
To that end, first place the upper side onto the motor base and then push
1
the lower side onto the appliance (2).
Warning: Do not operate the appliance when the pulp container is not
2
inserted.
Place the lid with the filling opening on the juice tray. Make sure that the
lid is positioned correctly in the juice tray. Then close the safety lock by
pulling the lever upwards until it clicks.
14
Place the jug under the juice spout.
Note: Fresh juice should not be stored in the jug. The juice oxidises quickly when it comes into contact
with air, which can impair its taste, colour and nutritional value. Apple and pear juice quickly becomes
brown.
If you prefer pure juice without foam, insert the foam filter in the jug.
Open the drip stop so that the juice can flow into the jug.
Note: The appliance only functions when all the parts are completely and correctly assembled and
when the safety lock on the lid has locked correctly into place.
Wash the required fruit/vegetables. If necessary, cut into small pieces so that they fit into the filling
opening without getting stuck.
Connect the mains plug to a mains socket and move the rotary switch to the required position:
Setting I: For soft fruit and vegetables such as watermelon, grapes, tomatoes, cucumbers and
raspberries.
Setting II: For all other types types of fruit and vegetable.
Insert the chopped pieces of fruit and vegetable into the filling opening.
Insert the stopper into the filling opening in the lid using the guides.
Press the stopper downwards slowly and steadily to extract as much juice
as possible.
If you press too hard, this can impair the quality of the juice. It can also
cause the micro-strainer to stop and can damage it.
Warning: Never place your hands, spoons or other foreign bodies (e.g.
hair, clothing, brushes, cloths) in the filling tube.
Once you have juiced all the pieces of fruit and vegetable and no more juice is running into the juice
jug, switch off the appliance and pull out the mains plug. Wait until the micro-strainer stops rotating.
Close the drip stop before removing the jug from the juice spout so that the juice residue does not
drip onto the work surface.
To remove the pulp container, switch off the appliance and remove it by gently tipping it forwards.
If the motor sticks, rotates slowly or stops during operation, switch off the appliance immediately and
pull the mains plug out of the mains socket.
Remove the micro-strainer and clean as described in the chapter „Cleaning and Care".

General guidelines

▪ Particularly suitable for processing are pineapples, beets, celery, cucumbers, carrots, spinach,
melons, tomatoes, pomegranate, oranges and grapes.
▪ Very hard and/or fibrous fruits and vegetables (such as sugar cane) are not suitable for the juicer.
▪ Starch-containing fruits such as bananas, papayas, avocados, figs or mangoes are not suitable for
the juicer. In order to process such fruits, use a food processor or a stand mixer.
▪ In order to extract as much juice as possible, press the pusher slowly and with a little downward
pressure.
▪ Make sure that the pulp container and the juice pitcher do not become too full. Otherwise, the
device might no longer work correctly.
15