HEIDELBERG Suprasetter A106 Installationsanleitung Seite 77

Health hazard caused by inhaling, swallowing the coolant or from eye or
skin contact with the coolant
Wear chemical-resistant protective gloves and respiratory and eye protection
when handling Glysantin.
Heed the warnings given in the safety data sheet or the note on the coolant con-
tainer.
1. Prepare the coolant made up of 1 part Glysantin, 3 parts chlorine-free drinking water in the mea-
suring cup (Fig. 70/2).
• Initial filling: ca. 1 liter
• Top-up filling: ca. 0.2 liters
2. Switch off the Suprasetter with the power switch.
3. Remove the cover (Fig. 70/1). To do so, take filler hose (Fig. 70/5) out of the snap clamp and
undo two screws.
Fig. 71 PCB 00.779.115
Note: For adjustment, use a dielectric pen.
1
Fig. 72 Reset button S3 and DIP switch S2
Suprasetter A106 – Installation
CAUTION
4. Plug X158 of the service pushbutton (Fig. 70/
3) to X158 on the chiller PCB (Fig. 71/1).
5. Set micro switch S2-3 of the 4-position DIP
switch (Fig. 72/3) on the chiller PCB down to
"OFF".
Installation
75