Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
1.) Unpack and check item for damage and completeness
2.) Changing equipment
Fault and troubleshooting
Fault/cause
Quick-release adapter wobbles on stand
Threaded bolt wobbles in the adapter
Storage, disposal
Store the Quick-Release adapter in a dry place.
Recycle disassembled components:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them according
u
to local regulations.
Contact information
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2
97877 Wertheim
Germany
23900-300-55 Rev.07 03-79-114-00 5/21
The Quick-Release Adapter is fully assembled.
For mounting on a stand, the lower threaded bolt must be unscrewed from the
reducing thread. This allows to screw the adapter onto a stand with a 3/8"
thread. If the reducing thread is removed, a 5/8" thread is available. Use a
coin to remove the reducing thread it sits too tightly.
Place the adapter on the stand and screw hand-tight.
To remove the threaded bolt or to change the equipment, press the K&M logo
on the grey locking ring and remove the threaded bolt upwards from the
Quick-Release Adapter.
It is allowed to mount a microphone, microphone clamp or any other equip-
ment with a 3/8" hreaded bolt.
Mounting is done in reverse order.
Press the K&M logo of the grey locking ring and insert the threaded bolt into
the quick-release adapter, release the locking ring, therefore locking the threa-
ded bolt together with the mounted equipment.
Check/Remedy
● Check screw connection between adapter and stand for
●
tightness and tighten if necessary.
● Check whether the threaded bolt is engaged in the adapter.
Phone: 09342/8060
Fax: 09342/806-150
E-Mail: contact@k-m.de
Web: www.k-m.de
Werbung
