Bolt Positions; Positioning Of Equipment On Vehicle - Fontaine 150SP Montage- Und Betriebsanleitung

150SP Fifth Wheel Instruction Manual
Figure 16 - Mounting Frame
Figure 17 - Sliding Fifth wheel
I N S T A L L A T I O N

5.5 Bolt positions

In all cases the Fifth wheel equipment should be mounted using
the mounting holes positioned as supplied. Where Pre-Drilled
holes are supplied in the vehicle chassis or fifth wheel equipment
these should always be used. If equipment appears to require
further modification then the Fontaine Technical Department
should be consulted prior to any alteration of the equipment.

5.6 Positioning of equipment on vehicle

Fifth wheel Equipment should always be fitted to the vehicle using
the vehicle manufacturer's fifth wheel position as this determines
the correct axle loading and compliance with national legislation.
In the case of sliding fifth wheels, when a ramp is supplied, the
slider should be positioned so that in its rearmost position it is clear
of the ramp.
If any doubt exists relating to the correct position of the
equipment on the vehicle then the Fontaine Technical
Department should be consulted.
IMPORTANT
Fontaine cannot accept responsibility for any loss or damage
caused by equipment which has been modified or that has not
been fitted in an authorised manner.
14
FIFTH WHEEL