Herunterladen Inhalt Inhalt Diese Seite drucken

Transportation And Storage; Troubleshooting - WilTec DP50 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

8. TRANSPORTATION/STORAGE
WARNING:
To avoid a fire, make sure to allow at least 20 minutes for cooling the water pump
down before transportation or storage in room.
Transport the water pump with the fuel cock turned off; besides, keep it horizontal
to prevent fuel from spilling. Spilled gasoline and gasoline vapour may ignite.
8.1 Make sure the storage site for the water pump is dry and clean.
8.2 Clean the water pump inside.
If the water pump is used to pump water with mud, sand or heavy debris, such deposits may re-
main inside it. Before storage, operate the water pump to suck into fresh water to wash, otherwise
impeller may be damaged once reused. After finishing washing, drive off the water drain plug, then
empty the water in the water pump thoroughly, and reinstall the water drain plug.
8.3 Empty the fuel tank.
WARNING:
Gasoline is extremely inflammable and explosive in certain conditions.
Turn the fuel cock to OFF position; drive off the fuel drain plug of the carburettor floater
chamber, drain out the fuel in the carburettor. Keep drained gasoline in proper container.
Turn the fuel cock to ON position.
Reinstall the fuel drain plug of the carburettor floater room.
8.4 Replace engine oil.
8.5 Dismount the spark plug, and fill clean specified engine oil into the cylinder, about one soup
spoon. Turn the engine several times to distribute oil evenly and then reinstall the spark plug.
8.6 Pull the starter handle towards until feel anti-action, and then continue pulling until the triangle
mark on the starter wheel lines up with the starter screw hole (see diagram below). In this location,
both the air inlet and exhaust valves are closed, which may prevent the engine inside from rusting.
8.7 Cover the water pump to protect it from dust.

9. TROUBLESHOOTING

9.1 Engine cannot start
Check according to the following:
Check if there is enough fuel;
Check if the fuel cock is turned on;
Check if the fuel enters the carburettor;
In the case that the fuel cock is turned on,
bottom of the carburettor.
WARNING:
Gasoline is extremely inflammable and explosive in certain conditions.
If fuel is spilled, be sure to wipe it dry before checking the spark plug and starting
up the engine, otherwise spilled fuel or fuel vapour may ignite.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Deutsch / English / Français
check through dismantle the fuel drain plug at the
Seite 39
Version 4.0

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Pp50Dp80Pp80Dp100Pp100

Inhaltsverzeichnis