Inhaltsverzeichnis
Werbung
1. SAFETY GENERAL RULES
Before operating, read the manual carefully and be sure to become familiar with it, otherwise
personal injury or death as well as severe parts damage may occur.
•
Before operating, perform the pre-operation inspection to make your operation on the water
pump safer.
•
For the sake of safety, it is forbidden to pump inflammable or corrosive liquids (such as gaso-
line or acid). Similarly, be sure not to pump corrosives such as seawater, chemical solution,
and alkaline liquids.
•
Locate the water pump on a firm and level ground. A sloped or over turned water pump may
result in fuel spilled out.
•
Operate a water pump in a well-ventilated place without fire resources and keep it at least
one meter away from other devices.
•
Because touching hot parts of the engine may get severe burns when operating the water
pump, keep children and pets far away from the operating site.
•
Master the method to quick stop the water pump; learn manipulating control devices. Using
the water pump without following the instructions in the manual is forbidden.
WARNING:
•
Gasoline is extremely inflammable and explosive in certain conditions.
•
Fill in gasoline in a well-ventilated place with the engine stalled. In gaso-
line filling and storage sites, be sure there are no smoking and fire re-
sources such as flame, fire spark and so on.
•
Do not spill gasoline out of the fuel tank. After filling, make sure to tighten
the fuel filler cap.
•
When filling, avoid spilling gasoline out, for spilled gasoline and gasoline
vapour is prone to ignite. Once gasoline is spilled out, make sure to wipe
it up before operation.
•
Don't run the engine in an enclosed room and poor-ventilated place, since
exhaust emission from the engine contain toxic carbon monoxide (CO),
which may make people lose consciousness, even lead to death.
2. PARTS DESCRIPTION
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
Deutsch / English / Français
(Fig.1)
Seite 30
Version 4.0
Werbung
Kapitel
Inhaltsverzeichnis
