Power Supply Of Laser - THEIS VISION H Gebrauchsanleitung

3. Power Supply of Laser

When the red LED of the Battery display is blinking the
battery is almost flat. You can work at least 1 hour. The
instrument will switch off.
Charge the battery at room temperature using only the
THEIS standard mains unit connected to the charger
socket below the laser. Charging at temperatures below
+5°C can lead to defects in the battery.
Charging is also possible during operation. Overloading
is not possible.
The LED is blinking alternating during charging the
battery. If the battery is charged ready, the LED is
constantly on, as long as the charger is connected.
Only use the charger on dry premises!
The batteries that are used with Eneloop™
technology have the advantage of low levels of self-
discharge. This means that if you do not use the
device, you only need to recharge it every six
months.
In the battery compartment, you can also use normal
alkaline mono-cells. Under no circumstances must you
recharge them. If you do this by mistake, the battery
symbol flashes.
Important: Observe the correct polarity. There are
± symbols on the base of the battery compartment.
Observe the disposal information in point 11.
Important: Because the battery poles and contacts
may soil over time, resulting in contact problems,
regular inspection and possibly cleaning with a soft
cloth and cleaning agent (spirit, alcohol) are neces-
sary.
17