Safety Rail; Resetting The Wash Basin Lifter - Pressalit MATRIX Gebrauchs- Und Pflegeanleitung

Safety rail

The wash basin lifters R4870 and R4875 are equipped with a safety rail .

Resetting the wash basin lifter

If the wash basin lifter is jammed, try to reset it .
① Make sure that the safety rail is not activated . Lower the wash basin lifter
all the way down to its starting position .
② Release the lowering button, and after 3-4 sec . press it in again until you
hear a slight click after approx . 10 sec .
③ Release the lowering button and then raise the wash basin lifter to its
highest position . You will hear another click .
④ Lower the wash basin lifter a couple of centimeters .
⑤ Raise it again to its highest position . You will hear another click .
The wash basin lifter is now reset . The wash basin lifter should also be
reset if there has been an interruption of the power supply .
If the safety rail comes in
contact with an object when
the wash basin is being lowered,
the motion stops immediately .
If an object comes is in contact with
the underside of the wash basin
when it is stationary, the safety
function is activated and the wash
basin is lifted .
The wash basin lifter can be used
again as soon as the obstruction has
been removed .
en
13