ASROCK H510M/ac Bedienungsanleitung Seite 29

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 18)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Fan Connector
(4-pin CHA_FAN2)
(see p.1, No. 4)
Chassis/Water Pump Fan
Connector
(4-pin CHA_FAN1/WP)
(see p.1, No. 19)
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
4 3 2 1
FAN_SPEED_CONTROL
CHA_FAN_SPEED
+12V
GND
1
GND
2 FAN_VOLTAGE
3
CHA_FAN_SPEED
4
FAN_SPEED_CONTROL
This header is for
connecting audio devices
to the front audio panel.
Please connect fan cable
to the fan connector and
match the black wire to
the ground pin.
This motherboard
provides six 4-Pin water
cooling chassis fan
connectors. If you plan to
connect a 3-Pin chassis
water cooler fan, please
connect it to Pin 1-3.
H510M/ac
25