LENCO PPR-100 Bedienungsanleitung Seite 14

Connecting to a Bluetooth
The radio can play audio files from Bluetooth
compatible mobile devices (smartphones, tablets).
Always refer to the instruction manual for your
mobile device.
Establishing a connection
1. Switch the appliance on.
2. Press MODE to select Bluetooth® mode blue.
3. Switch on your mobile device and activate the
®
Bluetooth -function.
4. Start scanning for devices on the external device.
5. Select Lenco PPR-100 from the list and connect the
devices. If a password is required, enter "0000".
Once the devices are paired, you will hear an audio
®
signal and the Bluetooth
permanently shown on the radio display.
®
device
®
-
symbol will be
If you switch off the radio, it will automatically
connect with the Bluetooth® device again once
it is switched back on, provided it is close-by
and the Bluetooth® function is activated. You
will hear an audio signal once the Bluetooth®
device has been found.
Disconnecting Bluetooth
There can only be one device connected to the radio via
®
Bluetooth at any time. If you would like to connect
another device, you must first disconnect the
connection which already exists:
1. Press MODE to select Bluetooth
2. Press and hold
hear two audio signals. The Bluetooth
will flash on the display – the device is now
disconnected.
Alternatively you can also disconnect the devices on
your mobile device.
14
®
devices
® mode blue.
for approx. 2 seconds until you
®
symbol