Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Safety Guidelines
1.
Follow the installation instructions.
2.
Use the appliance
• according to its intended use
• in good condition
• with due regard to safety and risk of danger.
3.
Note that the appliance is exclusively for use in the
applications detailed in these installation instructions
(see 2 Technical Data). Any other use will not be
considered to comply with requirements and would
invalidate the warranty.
4.
Please take note that any assembly, commissioning,
servicing and adjustment work may only be carried
out by authorized persons.
5.
Immediately rectify any malfunctions which may
influence safety.
2
Technical Data
Media
Medium:
Connections/Sizes
Connection size:
Pressure values
Max. operating pressure:
Maximum pressure
difference between hot and
cold inlet supplies:
Operating temperatures
Max. hot water inlet
temperature:
Flow rate:
Setting range:
Control accuracy:
MU1H-1369GE23 R0420
Drinking water
1
/
" - 2" (TM3400)
2
DN65 - DN80 (TM3410)
max. 10 bar
2 bar
90 °C
see diagram
30 - 45 °C (Set during
manufacture 40 °C)
36 - 53 °C (Set during
manufacture 48 °C)
45 - 65 °C (Set during
manufacture 55 °C)
±1 K
GB
3
Options
For Options visit homecomfort.resideo.com/europe
4
Assembly
4.1 Installation Guidelines
•
The thermostatic mixing valves can be installed in any
position
•
With any connections to be welded, during welding
remove the mixer so as not to damage the thermostat
and seals
•
It is recommended that interception valves are
installed on the connection ways to the mixer
•
The polystyrene packaging may be used as insulation
for the valve
5
Start-up
Changing the standard temperature TM3400 - TM3410
thermostatic mixing valves are fitted with a thermostatic
element set to a standard temperature and are adjusted at the
factory to the standard temperature (shown in the centre of
temperature plate F, and on the packaging).
This temperature can only be changed within the limits of the
corresponding adjustment range for the mixed water.
To make a change proceed as follows:
•
Temperature plate is pierced in the centre
usinghexagonal key included in the packaging.
•
Turning the screw clockwise raises the temperature of
mixture; accordingly to lower it, turn the key in an anti-
clockwise direction. The temperature of the hot water
should be at least 5 K more than that of the mixed
water.
6
Disposal
Observe the local requirements regarding correct waste
recycling/disposal!
3
Werbung
