Sanotechnik SANOSPA SPA08 Bedienungsanleitung Seite 52

NOTICE
1. all setting of pre-heating must be in Power OFF status, just connect the spa with
the power supply. and the LCD display "---".
2. please note that it shows "on" or "off" on the LCD, "on" means pre-heating is turn
on, when the time of pre-heating is the same as currently time, the heater will start
working. "off" means the heater can't start-up anytime.
3. Circulation PUMP and HEATER are not working while all setting time.
6. Pre-heating:
When the time of real time and pre-heating time is consistent, meanwhile, there is water in the
bathtub and the pre-heating button is"on", the system will start the pre-heating and circulation
pump and auto-constant temperature system will work at the same time. Then LCD will show
count down time (the two middle spot will not flash any longer) and corresponding working
status. In the pre-heating process, till cont down time finished. the pre-heating will be turned
off automatically by system or by pressing the "
NOTICE
1. When setting temperature is lower or equal water temperature, Even the Pre-
heating is working but the circulation PUMP and HEATER are not working.
2. When the HEATER is "I"frame, The power of circulation PUMP must reach 750W.
3. Answer for condition of "2", and the HEATER is not working, Please short the line
of water press switch.
7. circulation-cleaning:
When the time of real time and pre-heating time is consistent, meanwhile, there is water in the
bathtub and the circulation-cleaning button is "on", the system will start the circulation-
cleaning, and the circulation pump and ozone (If it is on) will work at the same time. Then LCD
will show count down time. In the circulation-cleaning process, till cont down time finished
the circulation-cleaning will be turned off automatically by system or by pressing "
intentionally.
8. Operation to Power ON/ OFF:
Pressing the key
At the same time, the LCD will show whether the power is on or off.
Fig.9: WAITTING MODE
52
will enter from ON to "Waitting Mode" or "Waitting Mode" to ON.
Fig.10: ON
PROGRAMMING INSTRUCTIONS
" key intentionally.
" key