Sanotechnik SANOSPA SPA08 Bedienungsanleitung Seite 49

3. Time setting operation:
In the status of "Waitting Mode" and the pre-heater and circulation cleaning are shut down,
pressing"
and Hour flash at this time. It will add 1 hour when pressing "
could be added continually when pressing the "
range is 0~23. In the status of time setting, It will add 1 minute when pressing "
time, and the minutes could be added continually when pressing the "
the minute adjustment range of the minute is: 0~59.
The system will quit the time-setting status automatically after 6 seconds without pressing.
4. Operation to circulation-cleaning settings:
Circulation-cleaning only works one times every day. The LCD can show clearly about
whether circulation-cleaning setting is startup or not. See following Fig. 5-6.
Fig.5: Circulation-cleaning
off
Circulation-cleaning setting must be in the "Waitting Mode" status and the LCD display "---".
(1)
(2)
(3)
(4)
the setting will
be finished
" or " " could start time setting. Signal of ":" doesn't flash but Minute
Fig.6: Circulation-cleaning
PROGRAMMING INSTRUCTIONS
" without stop. The hour adjustment
on
Close of Circulation-cleaning setting
Setting Start Time of Circulation
Setting Continual time of Circulation
" each time, and the hours
"each
" without stop.
49